2022-2024 RAM CUMMINS TUNER INSTRUCTIONS ETC.

Download Instructions

INSTRUCTIONS:

PLEASE NOTE: Recovery file is already requested and loaded to tuner, but still needs to be loaded to the new ecm after first steps with old ecm are finished.



VIDEO OVERVIEW OF FULL KIT INSTALL HERE.

For further support please see the support numbers below:

1-844-572-2363

Please phone 1-306-842-7223 if our Toll Free number above is not available in your area.

Please reference your order number when calling which we will send you.


ALREADY DONE - DO NOT UPDATE!
The Ultra device must be updated to
the latest firmware RAME 024B version before proceeding. |
VIEW UPDATE

1. Connect the Ultra device to the truck with the original ECM installed.

2. Key On, Engine Off, Tuner powered up –

Go to: Main Menu > Settings > Service Codes – Enter code 4666

ENTER

A message will appear IMMOBILIZER DATA SAVED FOR TRUCK

EXIT

3. Install the 2019-2021 ECM into the truck.

4. Fill out the Recovery Request Form and a recovery file will be emailed back to you with instructions.

5. Program the recovery file to the 2019-2021 ECM.

6. If the Recovery programming completes successfully, go to Step 7.

If the Recovery programming stops with ERROR 14101 / R 0D 1A 02 FF FF FF FF FF go to Step 8.

7. The truck/ECM is now ready to be programmed with a Custom Tune file as the last step.

8. On some NEW 2019-2021 ECMs that do not have an OEM flash on them, the Ultra may display an error 14101 when attempting to write the recovery file.

If error 14101 is displayed on the Ultra, please follow the instructions below.

9. Key On, Engine Off, Tuner powered up –

Go to: Main Menu > Settings > Service Codes – Enter code 6625

ENTER

The Ultra must display the message: ECM’s BL Data Read!

EXIT

10. Write Recovery to the ECM.

11. **NOTE** If at any time during the process Error 14075 appears on the tuner: Reset the ECM by disconnecting both negative battery cables for 30 minutes. Then retry the last step you were on.

12. Once Recovery is written successfully, the ECM is ready to be programmed with the Custom Tune file as the last step.

Dyno Diesels
Instruction Manual
Date
September 11, 2024
Category
Delete Bundles
PDF Download
Download Manual

Need Help with Installation?

Contact our support team for assistance with installation or any questions you may have.